Description of motion and impact forces of silicone cases

This is a paper that is focusing on the description of motion and impact forces of silicone cases. The paper also provides the areas for evaluation for writing this assignment paper.

Description of motion and impact forces of silicone cases

Your supervisors at A&L Engineering have tasked you with evaluating the durability of three common materials used in the design of cell phone cases. For each material type, you have been asked to determine the force of impact of a phone dropped from a set height above the ground. Using the mass of each case and the collision time, determine the force of impact on each case material and also determine which case material offers the most protection.
To facilitate your analysis, you have been provided with specifications for case materials in the table below. However, you may also use your own figures for the mass of phones and test case materials. If you do use a different figure, be sure to make that clear in your analysis.


To complete your evaluation of various materials for cell phone cases:

You must create a case material evaluation report that describes the motion and impact forces of several phone case materials under evaluation.
1.   Firstly, to begin your evaluation of different case materials, you must first define Newton’s laws of motion and then describe how each of Newton’s laws applies to the motion you will be analyzing. As you will be presenting this report to various stakeholders, you have been asked to write your definitions and descriptions with a nontechnical audience in mind.

2.   Secondly, once you have described the relevant laws of motion, create force diagrams to model the motion for a phone dropped from a set height. You should include diagrams, with their respective force vectors, for each phone drop. In your diagrams, address the following:
a.   Define the height you will be using for each phone drop. As the researcher, you will choose a drop height of between 1 and 2 meters.
b.   Using the provided mass of 6.2 oz, or by measuring the mass of a personal cell phone, determine the mass you will be using for your calculations. Remember to add the mass of the case material.
c.    In your diagram, show the direction and name of each force on the cell phone both at the drop point and at the point of collision with the ground.

Description of motion and impact forces of silicone cases

3.   Thirdly, following the creation of the force diagram:

Use the information provided in your case specification document to calculate the velocity before impact and deceleration at impact. Remember that deceleration is represented as negative acceleration in force equations. In your calculations, assume a standard free-fall acceleration during the fall, and a velocity of 0 m/s after the impact. You should include calculations for the following scenarios:
a.   A phone without a case
b.   A phone with a silicone case
c.    A phone with a hard plastic case
d.   A phone with a rubber case